90mm x 207mm Multifunctional Joist Hanger is a Face Fix Joist Hanger, produced from 2mm thick pre-galvanised mild steel in accordance with the specification given in the BS EN 10327:2004 DX51D+Z275. It is especially designed for timber to masonry and timber to timber fixings. It inclu..

Diameter: 63mmTeeth Size: 1.2mm63mm M10 Single Sided Tooth Plate Timber Connector is designed to improve bolt performance in timber joints. The connector's teeth must be embedded fully into the timber contact surface in order to achieve their design capacity. The connectors are p..

Masonry Return Joist Hanger is designed for similar applications and installation as the standard Masonry Joist Hanger. The return adds additional lateral support by wrapping around the back of the masonry or timber. The hanger has a 25mm drop on the return flange as standard. Any variatio..

90mm x 275mm Welded Masonry Joist Hanger is designed to support 275mm high timber joist. The joist hanger's actual height is 265mm, and the flange is built into brick or block wall. It has a minimum crushing strength of 3.5N/mm. Welded Masonry Joist Hanger is also suitable for many timber to ti..

300mm Arris Rail Bracket is suitable for securing arris rails to a square fence post when building a feather edge fence or to repair a broken wooden arris rail to an existing post. Made from galvanised steel EN 10346 DX51D Z275.Installation                &nbs..

75mm Stainless Steel Soffit Vent Mesh is for use in new build properties. It is used over vents in soffits to allow air flow to prevent condensation but prevents access to birds and insects. Made from Grade 1.4301 Austenitic Stainless Steel to EN 10088-2. Gloves should be worn as edges may be sharp...