63x225mm R100mm Welded Return Hanger

63mm x 225mm Welded Return Joist Hanger is designed for similar applications and installation as the standard Masonry Joist Hanger. The return adds additional lateral support by wrapping around the back of the masonry or timber. The hanger has a 25mm drop on the return flange as standard, but any variations can be made to order. Made from 2.4mm thick pre-Galvanised steel EN 10346 DX51D Z275. Also available in stainless steel.

Installation of 63x225mm R100mm Welded Return Hanger

• The back plate of the hanger should lie flat against the vertical masonry support.
• Masonry flange should have a minimum of 3 courses (675mm masonry) above.
• Both supporting and above masonry should be allowed to mature before any load is applied.
• Joist should be square cut and sit tight to the back of the hanger - maximum gap permitted is 6mm.
• Nail the side flanges with 30 x 3.75mm galvanised square twist nails or equivalent.
• To provide lateral restraint heavy duty straps should be used.
• The masonry flange should always be securely fixed or adequately embedded and should never be placed in dry slots.
• Always ensure that compatible corrosion resistant fixings are used, i.e. do not use galvanised fixings with stainless steel products or vice versa.
• Use correct strength mortar as per British Standard.

Specification

• Galvanised steel EN 10346 DX51D Z275 or grade 1.4301 austenitic stainless steel to EN 10088-2.
• Manufactured to EN 845-1:2013.
• Tested by CERAM Research Ltd Notification Body No.1289.