200mm Movement Ties are designed to provide restraint in one direction and movement to allow for horizontal expansion and contraction. The Debonding Sleeve is located over the embedment detail to allow the tie to move. Typical usages are in areas where masonry is restrained to Steelwork columns and ..

Galvanised Heavyt Duty Restraint Strap 1400mm Bent 150mm is designed for lateral and horizontal restraint (as in roof trusses). The straps are produced from edge coated galvanised mild steel, also available in stainless steel. They are designed for 6mm and 25mm offset centres holes.AP..

50x50mm Galvanised steel, powder coated Bolt Down Shoe. A fence post supports in both standard and heavy duty. Hole size M10. Installation To bolt down onto existing concrete. Suggested fixing 10 x 80mm sleeve anchor...

100mm x 250mm Welded Masonry Joist Hanger is designed to support 250mm high timber joist. The joist hanger's actual height is 240mm, and the flange is built into brick or block wall. It has a minimum crushing strength of 3.5N/mm. Welded Masonry Joist Hanger is also suitable for many timber to t..

Gauge: 0.4mmHole length: 20mmHole width: 10mm 8x2 Stainless Steel Expanded Metal Lath Sheet is mainly used for internal and external plaster when applied on suspended ceilings and walls. It is also suitable for encasing steel columns and beams, assisting in the protection from fire. Made o..

Straddle: 100mm75mm x 250mm Masonry Straddle Joist Hangers are designed for similar applications and installation as the standard Masonry Joist Hangers. The Masonry Straddle hanger is two hangers joined together by a plate on the masonry flange to enable exact alignment of two joists positioned..